[1.18] What's a dual-layer disc? Will it work in all players?

A dual-layer disc has two layers of data, one of them semi-transparent so that the laser can focus through it and read the second layer. Since both layers are read from the same side, a dual-layer disc can hold almost twice as much as a single-layer disc, typically 4 hours of video (see 3.3 for more details). Many discs use dual layers. Initially only a few replication plants could make dual-layer discs, but most plants now have the capability. The second layer can use either a PTP (parallel track path) layout where both tracks run in parallel (for independent data or special switching effects), or an OTP (opposite track path) layout where the second track runs in an opposite spiral; that is, the pickup head reads out from the center on the first track then in from the outside on the second track. The OTP layout is designed to provide continuous video across both layers. The layer change can occur anywhere in the video; it doesn't have to be at a chapter point. There's no guarantee that the switch between layers will be seamless. The layer change is invisible on some players, but it can cause the video to freeze for a fraction of a second or as long as 4 seconds on other players. The "seamlessness" depends as much on the way the disc is prepared as on the design of the player. OTP is also called RSDL (reverse-spiral dual layer). The advantage of two layers is that long movies can use higher data rates for better quality than with a single layer. See 1.27 for more about layer changes.

There are various ways to recognize dual-layer discs: 1) the gold color, 2) a menu on the disc for selecting the widescreen or fullscreen version, 3) two serial numbers on one side.

The DVD specification requires that players and drives read dual-layer discs. There are very few units that have problems with dual-layer discs--this is a design flaw and should be corrected for free by the manufacturer. Some discs are designed with a "seamless layer change" that technically goes beyond what the DVD spec allows. This causes problems on a few older players.

All players and drives also play double-sided discs if you flip them over. No manufacturer has announced a model that will play both sides, other than a few DVD jukeboxes. The added cost would be hard to justify since discs can hold over 4 hours of video on one side by using two layers. (Early discs used two sides because dual-layer production was not widely supported. This is no longer a problem.) Pioneer LD/DVD players can play both sides of a laserdisc, but not a DVD. (See 2.12 for note on reading both sides simultaneously.)